acsisedh
I am having difficulty folding down the dinette table on a 199fks.  Is there a release latch to do this?  I sent a message to Riverside but have not heard back from them.
Quote 0
Ralph L Staub
 If you're having problems with the leg, it probably just needs a little WD-40. There is no latch. 

If it's the wall attachment you're having problems with, it does not actually "fold" down, it detaches from the wall. Lift the front edge of the table 12 to 18 inches, and then lift the entire table out of the wall track.  Once it's lifted out of the track, you can set the table top between the two benches to create a bed. 
Quote 0
acsisedh
Thank you.  I wasn't lifting the table high enough.
Quote 0
GayleB
acsisedh wrote:
Thank you.  I wasn't lifting the table high enough.


That was my issue the first few times!  I almost have to lift it parallel to the wall and lift up.
Quote 0
Mic Tod
My table in our 177 is a bit difficult to remove too.  I sometimes remove it when we're camping and stow it under the bed - we eat outside almost exclusively (weather cooperating) and it gives us two small benches to sit on with more leg room inside our trailer.
Quote 0